P0705 P1702 Findings: found 2 loose ground connections in trunk area. tightened, cleared codes, drove, no codes currently.
STABILIZER BAR CONTROL LINK – Remove & Replace – Both Sides
AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – Right Side – [NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.]
TONY S. gave our service a 5 star review on 5/28/2021
Drain old oil from car. Remove & replace oil filter. Refill oil with motor oil. Check all fluid levels and tire pressures. Preform basic courtesy inspection.
MARYANNETOM H. gave our service a 5 star review on 4/27/2021
BALL JOINT – Remove & Replace – E150,E250 One Side,Both,Upper & Lower – [DOES NOT include alignment.]
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean. Recommend every 2 years/25,000 miles.
DISC ROTOR – Remove & Replace – E250,E350 Super Duty Rear,Both,Full Floating Axle,Inboard Mounted Rotor,Non Seperable – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
Drain old oil from car. Remove & replace oil filter. Refill oil with motor oil. Check all fluid levels and tire pressures. Preform basic courtesy inspection.
Two or Four Wheel Alignment: Align chassis to manufacturers specifications using factory adjustments.
WATER PUMP DRIVE BELT – Remove & Replace – Gas – [Includes: Serpentine type Belt(s).]
FRANK M. gave our service a 5 star review on 4/9/2021